If the fast icemaker wire is positioned correctly and is turned on proceed to check the freezer temperature. The temperature should be within the range of 0 to 8 degrees Fahrenheit. If it's above 10 to 12 degrees, your machine will not produce ice.
When you get to the house stand if front of the toilet and locate the water shut off valve. Should be down below the toilet on the wall. Just turn it off (righty-tighty) completely and flush the toilet. All the water should have left the tank, well at least most of it. If there is remaining water line repair get it out with paper towels or a rag. The important thing is that no more water came in. If it did then your valve is not shut all the way or not working and you need additional help.
You don't want to be paying your plumber to clear the area before they start work particularly if you are paying an hourly rate. Empty cupboards and make sure there is nothing that may cost the plumber time and you money gaining access to the job.
Depending on your repair job you might need a bucket that will fit below the sink trap, as well as some rags and newspaper. Masking tape is useful for labeling and for wrapping around the heads of the wrench to protect your chrome tap handles. Rubber gloves are recommended, particularly when working with the toilet, but there are greases and glues that you may not want on your hands.
Be certain that the bathroom exhaust fan vents to the outdoors, not into the house or attic. If the exterior vent dampers don't operate properly or water line repair don't seat well have them fixed or replaced.
99. With the large genoas it is difficult to see under the headsail. If sailing off the wind, harden up momentarily and sail for a few seconds closer to the wind and to observe the arc which had previously been blanketed. If sailing close hauled, bear away for a few moments.
The next huge thing is to prevent and kill mold that has already started growing. Mold is the most dangerous thing when an area floods. Mold can turn deadly within a extended period of time. Use mold killing agents like Killz and other products on the the market. Be extremely thorough with this process. If the water flooded above the dry wall line, you MUST remove the dry wall to make sure you can replace insulation and dry wall which mold naturally is attracted to. Painting a Killz primer on the concrete is a great idea before installing new carpet and drywall. This will ensure that you have prevented future mold growth and will also ensure the safety of your family.